Adjusting Chip Deflector - Delta RC-51 Instruction Manual

4.
Place the gage block (A) Fig.
roll (C). The bottom of outfeed roller (C) should just touch
the top of gage block (A) which would be
cutting circle.
5.
If an adjustment is necessary, loosen locknut (0)
30,
Fig. and turn adjustment screw (E) until the outfeed
roll just touches the top of gage block.
Repeat the adjustment at the opposite end of outfeed
6.
roller. Tighten lock nut (0) Fig.
made.
ADJUST CHIP DEFLECTOR
1.
DISCONNECT MACHINE FROM THE
SOURCE.
2.
Remove two screws (A) Fig.
chute (8).
3.
The edge (C) of the chip deflector (0) Fig.
be adjusted so it is a minimum of
.080"
of away from the cutting circle. Place a feeler gage
between the knife and the edge of the chip deflector as
32.
shown in Fig. If an adjustment is necessary loosen
three screws (E) and move chip deflector.
29,
underneath outfeed
.035"
below the
30,
after adjustment is
POWER
31,
and lift up on chip
32,
should
.040"
and a maximum
13
29
Fig.
30
Fig.
31
Fig.
32
Fig.