Cisco ASR 907 Installing page 51

Installing the Cisco ASR 907 Router
Step 2
Connect the other end of the shielded coaxial cable to the GNSS antenna after the primary protector.
Note
Note
Figure 30: Installing the GNSS Module in the RSP
1 Screw on the GNSS Module
Connecting Ethernet Cables
The Cisco ASR 907 Router interface modules support RJ45 or SFP Ethernet ports. For instructions on how
to connect cables to Ethernet SFP ports, see Connecting Cables to SFP Modules .
The RJ45 port supports standard straight-through and crossover Category 5 unshielded twisted-pair (UTP)
cables. Cisco Systems does not supply Category 5 UTP cables; these cables are available commercially.
The GNSS RF In port should have a primary protector installed to meet the Local Safety guidelines.
The GNSS RF In coaxial cable shield must be connected to the Facility Equipment Ground through
the chassis. The chassis must have the ground wire connected to the Facility Equipment Ground.
2 Inserting the GNSS Module
Connecting Ethernet Cables
Installing the Cisco ASR 907 Router
51