Installing the Cisco ASR 907 Router
• 48-port T1 RJ45 patch panel (part number DCC4884/25T1-S)
• 16-port E1 BNC patch panel (part number DCC16BNC/25T1-S)
The patch panels are available from Optical Cable Corporation (http://www.occfiber.com). To order a patch
panel, contact the Sales and Marketing Support staff at Optical Cable Corporation:
• 800-622-7711 (toll-free in the U.S.A.)
• 540-265-0690 (outside the U.S.A.)
Installing Patch Panel
To install the brackets on the rear of the patch panel, perform these steps:
Procedure
Step 1
Remove the larger (M4) rack mount screws (as indicated in the Rack Mount Screws figure below) from both
sides. To secure the brackets, follow the instructions in Step-3.
Step 2
Remove the patch panel rack-mount brackets from the accessory kit and position them beside the patch panel.
Step 3
Position the brackets against the patch panel sides, and align with the screw holes. Secure the rack mount
bracket to patch panel using a torque of 13.2 in.-lb (1.5 N-m) see the figure below.
Figure 36: Rack Mount Screws
(1) Rack mount screws to secure rack mount brackets on both the sides.
Installing Patch Panel
Installing the Cisco ASR 907 Router
59