Table of Contents
Advertisement
HOT AIR
PLENUM
3-1/2"
(8.9 cm)
SIDE OF HOTBLAST FURNACE
Drill one 7/8" hole as illustrated for placement of the Hotblast fan
limit control.
Your furnace is shipped from the factory in four (3) packages.
1) the furnace, 2) fan limit kit, 3) draft kit. Before assembling
the furnace, check to make sure there is no shipping damage,
and that all necessary parts are located in the firebox. See parts
list below.
If you find shipping damage or any of the parts missing, contact
the dealer immediately. He will take the necessary steps to
correct the problem.
Parts List
Parts List
Parts List
Parts List
Parts List
All models include the following:
Two Door Handles
One Fuel Door Latch
One Ash Door Latch
One Shaker Grate Handle
Two 1/2" Washers
Six 1/4" Hex Nuts
Four Lock Washers
Spin Draft
Five 1/4" Lock Nuts
One Pivot Bracket
Four Brass Coil Knobs
One 1/4" x 1" Hex Bolt
Three 1/2"-13 Lock Nuts
One 1/2" x 2 1/2" Carriage Bolt
Six 1/4" x 3/4" Hex Bolts
Smoke Door
Two 1/4" x 1-1/4" Carriage Bolts
Two Smoke Door Clips
Rod Extension
7/8" HOLE
6" (15.24cm)
ASSEMBL
ASSEMBLY INSTR
ASSEMBL
ASSEMBL
ASSEMBL
FAN LIMIT KIT
FAN LIMIT KIT
FAN LIMIT KIT
FAN LIMIT KIT
FAN LIMIT KIT
Fan Limit Control
Fan Center
F.A.D. Box
3-Speed Switch
Knob
All fires need air (specifically oxygen) to burn. Furnaces, fire-
places, and wood-burning furnaces need enough oxygen for
complete combustion of their fuels. The incomplete combustion
that takes place when a furnace is "air starved" causes carbon
monoxide (CO) to be formed in quantities that can be dangerous
inside a well-sealed house. Having a source of combustion air
from outside prevents this "air starvation" of the furnace.
Y INSTR
Y INSTRUCTIONS
Y INSTR
UCTIONS
UCTIONS
UCTIONS
Y INSTR
UCTIONS
DOOR HANDLE INSTALLATION
DOOR HANDLE INSTALLATION
DOOR HANDLE INSTALLATION
DOOR HANDLE INSTALLATION
DOOR HANDLE INSTALLATION
Insert door handle into door. From rear side of door place
1/2" washer over threaded part of door handle. Then attach
1/2" lock nut, being careful not to over tighten. Handle should
turn freely.
FUEL & ASH DOOR LATCH INSTALLATION
FUEL & ASH DOOR LATCH INSTALLATION
FUEL & ASH DOOR LATCH INSTALLATION
FUEL & ASH DOOR LATCH INSTALLATION
FUEL & ASH DOOR LATCH INSTALLATION
With two 1/4" x 3/4" hex bolts, attach the door latch to the
door latch mounting bracket on the left side of door frame as
illustrated. Adjust latch until door closes securely.
7
COMBUSTION AIR
COMBUSTION AIR
COMBUSTION AIR
COMBUSTION AIR
COMBUSTION AIR
FUEL DOOR
ILLUSTRATION
LOCK
WASHER
HEX
NUTS
FAN LIMIT
CONTROL ON
PLENUM
ASH DOOR
ILLUSTRATION
Advertisement
Table of Contents
