Assembly Of Furnace - USSC Clayton 1537Q Owner's Manual

Assembly of Furnace

Your furnace requires the following
items to be assembled or installed by
the service person:
Feed Door Handle
Feed Door Latch
Smoke Curtain
Blowers and Blower Controls
Electrical Connections
1. Remove all parts from inside the
furnace and inspect for damage,
including the firebrick as some
breakage could occur during ship-
ment.
2. Assemble the feed door handle
as shown in Figure 8. Install the
latch as illustrated in Figure 9.
3. Attach the smoke curtain to the
firebox as shown in Figure 10.
Install Honeywell thermostat on
4. rear of furnace cabinet as shown
in Figure 11.
Remove blowers from cartons.
5. Remove junction box cover. At-
tach clip nuts as per Figure 11.
Install blowers and gaskets with
1/4"-20 x 3/4" bolts as shown.
Wire right side blower first per
6. wiring diagram (Figure 12) and
replace cover on junction box on
blower.
Wire left blower same as above
7. and replace cover.
Complete all wiring in junction box
8. by referral to the wiring diagram
and Figure 11 - Blower and Com-
ponent Assembly. Replace cover
on junction box.
Check operation of shaker grates
9. with grate handle before operat-
ing furnace.
WASHER
LOCKNUT
FIG. 8
FIG. 9
CARRIAGE BOLT
10
FEED DOOR HANDLE
SMOKE DOOR CLIP
SMOKE CURTAIN
FIG. 10
NUT