To Do A Check Of The Transmission Oil Level; To Fill Fuel - Husqvarna Rider 213C Workshop Manual

3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in and tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole that the dipstick sits in.
Fill the oil slowly.
Technical data on page 54 for the types
Note: See
of engine oil that we recommend. Do not mix
different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.

4.9 To do a check of the transmission oil level

Note: Do the transmission oil check when the
transmission is cool.
420 - 002 - 22.03.2018
Note: All models do not have a transmission oil tank.
1. Remove the screws, one on each side, and remove
the transmission cover.
2. Make sure that the oil level in the transmission oil
tank is between the 2 horizontal lines on the tank.
3. Fill with engine oil if the oil level is below the lower
line, but do not fill above the top line. See
data on page 54 for recommended oil.

4.10 To fill fuel

WARNING: Gasoline is very flammable. Be
careful and refuel outdoors (see
instructions on page 4 ).
WARNING: Do not use the fuel tank as a
support area.
CAUTION: Incorrect type of fuel can result in
engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.
Max
Min
Technical
Special safety
Assembly - 9