4. Measure the distance between the belt adjuster and
the belt guide. Correct distance is 17 +/- 5 mm. Do a
check of and adjust the belt adjuster.
5. Adjust the belt adjuster with the adjustment screw if
the distance is not 17 +/- 5 mm.
9.9.6 To remove the equipment belt
Note: Remove the equipment belt when you attach a
snow blade on the product.
1. Put the cutting deck into servicing position.
2. Pull the center belt off the center pulley. The tension
of the equipment belt loosens when the cutting deck
is in servicing position.
3. Remove the equipment belt from the center pulley.
420 - 002 - 22.03.2018
9.9.7 To install the equipment belt
1. Put the equipment belt between the impeller and the
idler pulley.
2. Put the equipment belt in the top groove and the
center belt in the bottom groove of the center pulley.
3. Put the cutting deck in cutting position. See
the cutting deck in mow position on page 41 .
To put
Repair instructions - 49