Husqvarna Rider 213C Workshop Manual page 39

5. Press the ball joint onto its bracket and attach the
locking spring.
6. Attach the ball joint onto the rear part of the
hydrostatic transmission cable. Turn the ball joint
10-12 turns until the ball joint is the correct length.
7. Pull the hydrostatic transmission cable along the
other cables.
8. Put the hydrostatic transmission cable in the rear
casing bracket and attach the rear clamp.
9. Adjust the hydrostatic transmission cable. See
adjust the hydrostatic transmission cable on page
38 .
10. Connect the rear ball joint and attach the locking
spring.
A
11. Tighten the locknut for the rear ball joint.
12. Attach the tunnel cover. See
on page 17 .
13. Operate the product forward and rearward to make
sure that the transmission functions correctly.
420 - 002 - 22.03.2018
(10–12 x)
B
To remove the covers
9.5.12 Transmission maintenance
9.5.12.1 To adjust the transmission neutral position
WARNING: Engine exhaust contains poisonous
carbon monoxide. Attach an exhaust hose
before you start the engine indoors.
1. Bleed the hydraulic system. See
system on page 31 .
2. Put the product on the adjustment tool for wheel
speed. See
3. Turn the adjustment shaft on the transmission to
adjust the neutral position.
4. Start the engine and give it full throttle.
5. Loosen the locknut (A) on the transmission
adjustment shaft.
6. Turn the adjustment shaft (B) clockwise until the
wheels start to turn rearward.
7. Make a mark at the position where the wheels start
to turn.
To
8. Turn the adjustment shaft (B) counterclockwise until
the wheels start to turn forward.
9. Make a mark at the position where the wheels start
to turn.
10. Turn the adjustment shaft (B) clockwise to the
middle position between the marks.
9.5.12.2 To replace the oil in the front and rear
hydrostatic transmissions
WARNING: Transmission oil is dangerous to
your skin. Clean spills with soap and water.
WARNING: Used oil and filters are dangerous
to the environment. Discard used chemicals at
an applicable disposal location.
To bleed the drive
Servicing tools on page 13 .
A
B
Repair instructions - 39