Electrical System - Husqvarna Rider 213C Workshop Manual

Note: Do not change the steering angle.
4. Make a mark on the wheels on the adjustment tool
for wheel speed with reflective tape (B) or
equivalent.
5. Start the engine and let it warm up at full speed until
the wheel speed is stable.
WARNING: Running an engine in a closed
area with low airflow can result in death
because of asphyxiation or poisonous
carbon monoxide.
6. Measure the wheel speed with a tachometer (C) at a
maximum distance of 10 cm from the wheel (D).
Make a note of the rpm of the rear wheel at full
speed. Then measure the speed of the front wheel,
it must be between 0-5% lower than the rear wheel
speed.
7. Stop the engine.
9.3.1 Electrical system overview
1. Battery
2. Main fuse
3. Seat safety switch
4. Microswitch, parking brake
5. Safety switch for the lift lever
420 - 002 - 22.03.2018
6
5
8. Adjust the turning speed of the wheels with the
adjusting rod. First loosen the locknuts.
B
a) A longer rod gives the front wheels a higher
speed.
b) A shorter rod gives the rear wheels a higher
speed.
9. Do a check that the adjustment is correct. If not, do
step 6 – 8 again.
10. Tighten the adjusting rod locknuts when the
adjustment is complete.

9.3 Electrical system

1
2
6. Ignition lock
A
3
4
Repair instructions - 27