Husqvarna Rider 213C Workshop Manual page 33

6. Disconnect the hydraulic pipes from below the front
transmission and attach protective plugs.
7. Remove the front left footrest plate. See
the covers on page 17
8. Disconnect the hydraulic pipe from the top of the
front transmission and attach protective plugs.
9. Remove the 5 screws that hold the front
transmission and lower the front transmission.
420 - 002 - 22.03.2018
10. Remove the parking brake cable from the front
transmission.
To remove
11. Loosen the 2 stop screws and remove the bearing
on the right side.
9.5.9.2 To assemble the front transmission
Obey the instructions in
clean on page 30 .
1. Assemble the front transmission in opposite
sequence. See
transmission on page 32 . Tighten the left side
bearing before the right side bearing.
2. Tighten the screws that hold the front transmission
before tighten the screws for the right side bearing.
To keep the hydraulic system
CAUTION: Hold the connection nut with a
wrench to prevent damage from twisting forces
to the pipes or elbow nipples.
To disassemble the front
Repair instructions - 33