Base Unit; Base Attachment - Bosch MFW35 Series Instruction Manual

Base unit

Preparation
W Warning
Risk of injury!
Do not insert the mains plug until all
preparations for working with the appliance
are complete and the required attachments
are assembled correctly and connected to
the base unit.
■ Place the base unit on a stable and level
work surface.
■ Pull the mains cable out of the cable
storage compartment to the required
length.
The base unit is now prepared.

Base attachment

The base attachment can be used for the
following a pplications:
Meat mincer
For chopping up raw or cooked food. Select
the appropriate perforated disc depending
on the type and consistency of the food to
be processed. X "Tips" see page 25
Sausage filler
For filling artificial and natural casings with
sausage meat. For producing meat rolls.
Kebbe maker
For producing tubes of dough or minced
meat.
Note: Other applications are possible
using the base attachment and appropriate
accessories available from Customer
Service.
Caution!
When assembling the different individual
parts, make sure that the notched markings
on the inserts match up with the relevant
one on the housing.
MFW3_EU_8001019358.indb 21
Preparation for meat mincer
W Warning
Risk of injury!
Do not reach into the sharp knife.
Caution!
Always only use one perforated disc.
X Fig. D
1. Insert the worm gear with the agitator
paddle at the front in the housing.
2. First fit the knife and then the required
perforated disc onto the w orm gear.
3. Fit the threaded ring onto the housing
and screw tight in a clockwise direction
without using force.
The meat mincer is now prepared.
Preparation for sausage filler
X Fig. E
1. Insert the worm gear with the agitator
paddle at the front in the housing.
2. First fit the bearing ring onto the worm
gear and then the sausage nozzle into
the housing.
3. Fit the threaded ring onto the housing
and screw tight in a clockwise direction
without using force.
The sausage filler is now prepared.
Preparation for kebbe maker
X Fig. F
1. Insert the worm gear with the agitator
paddle at the front in the housing.
2. First fit the conical ring onto the worm
gear and then the kebbe nozzle into the
housing.
3. Fit the threaded ring onto the housing
and screw tight in a clockwise direction
without using force.
The kebbe maker is now prepared.
Use
Note: The food is processed in different
ways depending on the application.
X "Recipes" see page 24
Base unit en
21
01.12.2015 12:05:48