Control And Display Elements; Overload Protection; Reversing Function - Bosch MFW35 Series Instruction Manual

en Control and display elements
Control and display
elements
MFW35...
Button I
Press button I to switch on the appliance.
The drive will start up at once.
Button O
Press button O to switch off the appliance.
The drive stops.
MFW36.../MFW38...
Button k
Press button k to switch on the appliance.
The drive will start up at once. Press button
k again to switch off the appliance. The
drive stops.
rev button
Press the rev button to start the reversing
function. Release the rev button to stop the
reversing function. X "Reversing function"
see page 20
All models
Operation indicator
The operation indicator lights up when the
appliance is switched on. On models with
the reversing function the function indicator
flashes for as long as the rev button is
pressed.
Release button
Press the release button to unlock an
attachment fitted on the appliance. Only
when the release button is pressed is it
possible to turn the attachment clockwise
and remove it from the base unit.
Cable storage compartment
The mains cable can be pulled out of the
cable storage compartment or pushed back
in again. Only ever pull the cable out as
much as is required.
Storage compartment
Unused perforated discs belonging to the
meat mincer can be kept in the storage
compartment and it closed with the cover.
20
MFW3_EU_8001019358.indb 20

Overload protection

To prevent serious damage to your
appliance if the base attachment is
overloaded, the agitator paddle has a
notch (predetermined breaking point). If
overloading occurs, the agitator paddle
will break at this point. A new agitator
paddle is available from Customer
Service (No. 630701). Spare parts with
a predetermined breaking point are not
covered by our warranty obligations.
Replace agitator paddle
X Fig. C
1. Release the screw in the agitator paddle
with a screwdriver (PH2) and remove
the faulty paddle.
2. Fit a new agitator paddle and screw tight
again.

Reversing function

ONLY MFW36.../MFW38...
The reversing function is designed to
release food that has got stuck by briefly
running the worm gear in reverse. The
reversing function switches off automatically
after 15 seconds.
Caution!
– Never operate the appliance for any
length of time in the reversing function.
– Never press the rev button while the
appliance is switched on. Only press
the rev button once the appliance has
completely stopped.
■ Switch the appliance off with button k
and wait until the drive has stopped.
■ Press the rev button briefly and wait
until the drive has stopped.
■ Switch the appliance on again with
button k.
Note:
If food that has got stuck is not released by
briefly putting the appliance into reverse,
switch the appliance off, unplug and
clean it. X "Care and daily cleaning" see
page 23
01.12.2015 12:05:48