Cisco 8961 Administration Manual page 351

Cisco Unified IP Phone Non-Lockable Wall Mount
Components
The following figure shows the components of the ADA Non-Lockable Wall Mount Kit for 8961 Series and
9900 Series IP Phones.
Figure 18: Components
The package contains the following items:
• One phone bracket
• One wall bracket
• Four #8-18 x 1.25-inch Phillips-head screws with four anchors
• Two #4-40 x 0.31-inch machine screws
• One 6-inch Ethernet cable
Before You Begin
You need these tools to install the bracket:
• #1 and #2 Phillips-head screwdrivers
• Level
• Pencil
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not
currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular
telephone jack. For more information about phone installation requirements and warnings, see
IP Phone Installation, on page
REVIEW DRAFT - CISCO CONFIDENTIAL
38.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
Components
Cisco Unified
(SIP)
327