Jøtul Lillehammer Installation And Operation Instructions Manual page 4

139955-01 GF 200 DVII MV / Sept. 2019
Suggested Tools for Installation and Service
• External regulator (for Propane only)
• Piping which complies with local code
• Manual shut-off valve -
T-Handle required in Massachusetts
• Sediment trap - if required by code
• Tee joint
• Pipe wrench
• Pipe sealant
• 10 mm open end wrench
• 1/2", 7/16" open end wrench
• Phillips head screwdriver
PLEASE NOTE:
Initial Break-in
It is normal for smoke and odor to occur during
the initial stages of operation, depending upon
temperatures generated over time. This "curing"
condition can be alleviated by promoting fresh air
circulation within the immediate vicinity of the
appliance.
Operation Sound
Please be aware that cast iron and steel components
expand and contract with temperature fluctuations
that are often accompanied by "creaking" or
"pinging" sounds. This is the result of natural
thermal activity.
4
We recommend that
�
our gas products be
installed and serviced by
professionals who are
certified in the U.S. by
the National Fireplace
Institute® (NFI) as NFI
Gas Specialists.
• Flat head screwdriver
• 1/4" nut driver
• Work Gloves
• Safety glasses
• Torx T-20 screwdriver
• Tin snips
The optional blower
fan will also generate
a slight hum at the
low setting and
progressively increase
with the velocity of
forced air.
Installation Requirements for the
Commonwealth of Massachusetts
THIS PRODUCT MUST BE INSTALLED BY A
LICENSED MASTER OR JOURNEYMAN PLUMBER
OR GAS-FITTER WHEN INSTALLED IN THE
COMMONWEALTH OF MASSACHUSETTS.
1. If there is not one already present, on each
floor level where there are bedroom(s), a
carbon monoxide detector and alarm shall
be placed in the living area outside the
bedroom(s). The carbon monoxide detector
shall comply with NFPA 720 (2005 Edition).
2. A carbon monoxide detector shall:
a) Be located in the room that houses the
appliance or equipment;
b) Be either hard-wired or battery powered
or both; and
c) Shall comply with NFPA 720 (2002
Edition).
3. A Product-approved vent terminal must be
used, and if applicable, a Product-approved
air intake must be used. Installation shall be
in strict compliance with the manufacturer's
instructions. A copy of the installation
instructions must remain with the
appliance or equipment at the completion
of the installation.
E
lectrical Hazards
 Be aware of electrical wiring locations
when cutting holes in walls and ceilings
for termination.
 The blower must be electrically grounded
in accordance with local codes or, in the
absence of local codes, with the current
ANSI/NFPA 70, National Electrical Code or
CSA C22.1-Canadian Electrical Code.
 The Blower is supplied with a three-prong
(grounding) plug for protection against
shock hazard and should be plugged di-
rectly into a properly grounded three-prong
receptacle.
DO NOT CUT OR REMOVE THE GROUNDING
PRONG FROM THE PLUG.
 Always disconnect the power supply
when performing routine service on the
fireplace.