Cisco Catalyst IW6300 Heavy Duty Series Installing Manual page 9

Installing the Access Point
Table 2: Materials Needed to Mount Access Point on a Pole
Mounting Method
Vertical or streetlight
pole
To mount the access point onto a vertical pole, follow these steps:
Procedure
Step 1
Select a mounting location on the pole to mount the access point. You can attach the access point to any pole
from 2 to 16 inch (5.1 to 40.6 cm) in diameter.
Step 2
For poles larger than 3.5 inch (8.9 cm), mount the pole clamp bracket assembly to a pole using two metal
straps. Following the instructions provided with the banding strap tool (BAND IT) (AIR-BAND-INST-TL=),
loop each metal strap twice through the slots on the strap bracket.
Caution
Figure 8: Clamp Bracket Assembly Mounted on Poles Larger than 3.5 inch (8.9 cm)
Materials Required
Two 0.75-in (1.9 cm) stainless steel bands
Banding strap tool (BAND IT) (Cisco AIR-BAND-INST-TL=)
Ground lug (provided with access point)
Crimping tool for ground lug, Panduit CT-720 with CD-720-1 die
(http://onlinecatalog.panduit.com)
#6 AWG ground wire
Do not place the metal straps in the large open area between the pole clamp bracket and the strap
brackets because this does not properly secure the access point.
Pole Mounting
Installing the Access Point
In
Kit
Yes
No
Yes
No
No
9