Cisco Catalyst IW6300 Heavy Duty Series Installing Manual page 3

Installing the Access Point
Figure 2: Unit Dimension - Side
Mounting the Access Point on a Wall
The optional pole mount kit contains a mounting bracket for wall mounting. You can use the mounting bracket
as a template to mark the positions of the mounting holes for your installation. You then install the mounting
plate, and attach the access point when you are ready. The following table lists the material that you will need
to provide in addition to the pole mount kit.
Table 1: Material Needed to Mount Access Point to a Vertical Wall
Materials Required
Ground lug and screws (provided with access point)
Crimping tool for ground lug
Four M8 or 5/16 in. (31 mm) screws
Four wall anchors (specified for wall material)
Drill bit for wall anchors
Mounting the Access Point on a Wall
In
Kit
Yes
No
No
No
No
Installing the Access Point
3