Cisco Catalyst IW6300 Heavy Duty Series Installing Manual page 16

Antenna Selection Examples
Cisco Industrial Routers and Industrial Wireless Access Points Antenna Guide
http://www.cisco.com/c/en/us/support/wireless/aironet-antennas-accessories/products-installation-guides-list.html
Follow all safety precautions when installing the antennas. For information on safety, see
When Installing
Antenna Selection Examples
The following examples list suggested antenna and RF accessory selections for typical installation scenarios.
Use Case Antennas
Omnidirectional 2x Dual-Band
access coverage Omni-Directional
on both radios Antennas
AIR-ANT2547V-N,
AIR-ANT2547VG-N,
AIR-ANT2547V-N-HZ,
or AIR-ANT2568VG-N
Omnidirectional 2x Dual-Band
access on 2.4 Omni-Directional
GHz, backhaul on Antennas
5 GHz AIR-ANT2547V-N,
AIR-ANT2547VG-N,
AIR-ANT2547V-N-HZ,
or AIR-ANT2568VG-N
or 2x 2.4 GHz 5 dBi
Omnidirectional
Antennas
AIR-ANT2450V-N,
AIR-ANT2450VG-N,
AIR-ANT2450V-N-HZ,
or AIR-ANT2450HG-N
or 2x 2.4 GHz 8 dBi
Omnidirectional
Antennas
AIR-ANT2480V-N and
1x 5 GHz 13 dBi
Directional Antenna
AIR-ANT5114P2M-N=
Installing the Access Point
16
Antennas.
Coaxial Cables
None
2x N(m) – N(m) cables:
CAB-L400-5-N-N
CAB-L400-5-N-NS
CAB-L400-20-N-N
CAB-L600-30-N-N
or
AIR-CAB025HZ-N
Lightning Installation
Arrestors and/or
Adapters
None Connect antennas directly
to ports A and B. Cap
ports C and D with
weatherproof caps.
2x N(m)-N(f) Connect the two 2.4 GHz
Lightning Arrestor omnidirectional antennas
directly to ports A and B.
CGR-LA-NM-NF
Mount the 5 GHz
and directional antenna with
the included hardware
2x N(f)-N(f)
and connect it to ports C
adapter
and D via the adapters,
AIR-ACC370-NF-NF
coaxial cables, and
lightning arrestors (if
required).
Installing the Access Point
Safety Precautions
Antenna
Mode
Configuration
Dual band
Single band