Cisco Catalyst IW6300 Heavy Duty Series Installing Manual page 8

Pole Mounting
Figure 7: Assembled Pole Clamp Bracket and Strap Brackets
1
3
Step 2
Screw the M8 nut onto the pole clamp bracket support bolt, and tighten just enough to prevent the bolt from
falling off.
Step 3 Go to
Pole Mounting
To mount your access point on a vertical pole, you need to install two metal bands around the pole to support
the access point. This process requires extra tools and material not provided in the pole mount kit (see the
following table).
Installing the Access Point
8
M8 x1.25x16 bolts (with lock washers)
Strap bracket (shown positioned for 11 to
16 inch diameter pole)
Pole Mounting, on page 8.
2 Pole clamp bracket
Installing the Access Point