Connect Programmer To Solartouch Control Panel - Pentair SOLARTOUCH 521606 Installation Manual

6
Connect Programmer to SolarTouch
3. With the front (LEDs) of the PICKit
the programmer (pin 1 on right side) onto the 5-pin connector (pin 1 on
right side) on the control panel circuit board (PCB) as shown below.
Pin slot on PCB
(not used)
Pin 1 on PCB
USB Cable to
PC USB Port
SolarTouch
Circuit Board
Pins 1-5
PICKit 4 programmer plugged into SolarTouch Controller circuit board.
4.
Switch ON power to the SolarTouch Controller.
5. Next, load the MPLAB IDE software.
Continue with Launching the IPE Programming Application on the next page.
SolarTouch Controller Firmware Update User's Guide
® Control Panel (Continued)
4 programmer facing you, connect
®
Pin 1
Pin 5
Note: Be sure to align Pin
1 on the programmer and
Pin 1 on the SolarTouch
circuit board