Connecting The Programmer - Pentair SOLARTOUCH 521606 Installation Manual

Connecting the Programmer

Connect the USB cable (provided) to the programmer and to a USB
port on the PC. Note: If a USB hub is being used, the hub must be
powered with its own power supply.
Connect Programmer to SolarTouch
1. Open the front cover of the controller. Remove the three (3) screws
securing the control panel. Flip the control panel up to access the
control panel circuit board. Note: Be careful not to stretch the ribbon
cable connecting the control panel to the main circuit board.
2. Locate the 5-pin header programming connector JP2 on the control
panel circuit board. Note where pin 1 is located.
5-pin header
programming
connector
PICKit 4 programmer
®
Pin 1
SolarTouch Control Panel Circuit Board
SolarTouch Controller Firmware Update User's Guide
®
Control Panel
5