Panic Mode - Ultra Start 72 Series Owner's Manual

72 SERIES
OWNER'S MANUAL
HOLD

PANIC MODE

When the lock button is held for 5 seconds the system will enter Panic Mode.
The LEDs under the buttons will flash in a pattern and the remote will beep to
indicate Panic Mode is active. If the system is not in range the remote will
beep 3 times.
LOCK
HOLD
TRUNK RELEASE
When the unlock button is held the light behind the button will flash twice and
the remote will beep twice after 3 seconds the remote with beep again as
confirmation that the function has been completed. If the system is not in
range the remote will beep 3 times.
UNLOCK
COLD START MODE
1- Press and release the # button then within 3 seconds hold the start button for 8 seconds.
2- All 4 LEDs on the remote will illuminate to indicate that the start cycle selection. Within 3
seconds select the start cycle
a. Press Unlock for 2hr timer. LEDs will flash twice as confirmation.
b. Press Start for 3hr timer. LEDs will flash three times as confirmation.
c. Press # for 4hr timer. LEDs will flash four times as confirmation.
PRESS AND
RELEASE
LOW BATTERY WARNING
When the battery voltage is low all of the LEDs behind the buttons will
LOW
activate at the same time and the remote will beeps once immediately when
BATTERY
a button is pressed. Range and features such as Panic Mode and Trunk
Release may not function when the batteries are low.
(See page 13 for more details)
THEN
PRESS AND
HOLD
LED 2 WAY
LED 2 WAY SYSTEMS
HOLD 8 SEC.
PAGE 16