80 SERIES
OWNER'S MANUAL
Timer Mode will start the vehicle at a user selectable start interval or by temperature.
The vehicle will start at the selected start interval/ temperature and run for the
programmed runtime*. EXAMPLE: If the 4 hour start cycle was selected, the vehicle
will start once every 4 hours. (Default 15 minutes)
Press and Hold
While the park lights are on the start cycle may be selected. See below:
PRESS
Sets for temp 1 (0c/ 32f) temp sensor must be installed. Programs for one hour start interval w/o temp sensor.
Sets for temp 2 (-5c/ 23f) temp sensor must be installed. Programs for two hour start interval w/o temp sensor.
Sets for temp 3 (-15c/5f) temp sensor must be installed. Programs on three hour start interval w/o temp sensor.
Sets for temp 4 (-25c/ -13f) temp sensor must be installed. Programs on four hour start interval w/o temp sensor.
NOTE: Timer Mode must be set each time the user wishes to use this feature.
Reservation Mode must be set (Manual Transmission Only) to enter Timer Mode.
To Cancel Timer Mode
Press and Hold
Note- Timer Mode will automatically turn off after 24 hrs. Pressing the brake pedal or
turning the ignition to the ON position will also cancel Timer Mode.
IMPORTANT: Never remote start or set the Timer Mode if the vehicle is parked
in a Garage or Attached Carport!
for 3 seconds or until the park lights turn on.
for 3 seconds or until the park lights flash twice.
SYSTEM PROGRAMMING - Menu 1
SYSTEM OPERATIONS
PAGE 14