Product Reclamation And Recycling Program - Juniper CTP1000 Series Hardware Manual

Chapter 2: Installing a CTP System
If the router or switch is set to full duplex or 100-Mbps speed, or both, then you
must set the configuration of the CTP system to the same configuration by using the
Node Operations menu (see Node Operations and Maintenance on page 69 in CTP
Software Configuration Guide, Chapter 2, Software Configuration).
You must explicitly disable proprietary router protocols on the interface, such as
Cisco Discovery Protocol (use the interface configuration command NO CDP). You
must also turn off any options to power external voice-over-IP (VoIP) phones
through the Ethernet.

Product Reclamation and Recycling Program

Juniper Networks is committed to environmentally responsible behavior. As part of
this commitment, we work to comply with environmental standards such as the
European Union's Waste Electrical and Electronic Equipment (WEEE) Directive and
Restriction of Hazardous Substances (RoHS) Directive.
These directives and other similar regulations from countries outside the European
Union regulate electronic waste management and the reduction or elimination of
specific hazardous materials in electronic products. The WEEE Directive requires
electrical and electronics manufacturers to provide mechanisms for the recycling
and reuse of their products. The RoHS Directive restricts the use of certain
substances that are commonly found in electronic products today. Restricted
substances include heavy metals, including lead, and polybrominated materials.
The RoHS Directive, with some exemptions, applies to all electrical and electronic
equipment.
In accordance with Article 11(2) of Directive 2002/96/EC (WEEE), products put on
the market after 13 August 2005 are marked with the following symbol or include it
in their documentation: a crossed-out wheeled waste bin with a bar beneath.
Juniper Networks provides recycling support for our equipment worldwide to
comply with the WEEE Directive. For recycling information, go to
http://www.juniper.net/environmental , indicating the type of Juniper Networks
equipment that you wish to dispose of and the country where it is currently located,
or contact your Juniper Networks account representative.
Products returned through our reclamation process are recycled, recovered, or
disposed of in a responsible manner. Our packaging is designed to be recycled and
should be handled in accordance with your local recycling policies.
35
Product Reclamation and Recycling Program