CTP 5.2 Hardware Guide
CTP2000-Series Modules
Serial Interface Modules
CTP2000-IM-8P-T1E1 Interface Module
14
CTP2000-Series Modules
The following CTP2000-series interface modules are available.
The CTP2008, CTP2024, and CTP2056 systems have up to one, three, and seven
serial interface modules, respectively. The interface modules are interchangeable
between the systems.
The following interface modules have two 100-pin connectors similar to the
connectors provided on the CTP1004 and CTP1012 systems. Each connector
provides four ports by means of the quad cable. (See "Cables" on page 28.) See
Figure for port numbering. The lowest-numbered ports start at the top right.
CTP2000-IM-8P—Provides the standard software-configurable data interfaces,
including EIA530, EIA530A, RS-232, and V.35; 8 port.
CTP2000-IM-8P-T1—Provides the standard software-configurable data
interfaces, plus a configurable T1/E1 interface; 8 port.
CTP2000-IM-8P-V—Provides the standard software-configurable data
interfaces, plus a configurable 4WTO interface; 8 port.
Figure 18: Serial Interface Module
Connector: se - x/4-7
The CTP2000-IM-8P-T1E1interface module has RJ-48 ports numbered left to right
(0-7). It provides a configurable E1 (2.048 MHz) or T1 (1.544 MHz) interface with
AMI or B8ZS encoding; 8 port. (See Figure 19.)
Figure 19: CTP2000-IM-8P-T1E1 Interface Module
0
1
2
3
Connector: se - x/0-3
4
5
6
7
CTP2000 IM-T1/E1