Table of Contents
Advertisement
CTP1000-Series Models
The following CTP1000-series models are available.
CTP1002
The CTP1002 system has a removable flash drive accessible from the front. You can
remove the flash drive by pressing the eject button next to the card. The CTP1002
system must be powered off when you insert or remove the flash drive. The
CTP1002 front panel (Figure 1) includes:
Figure 1: CTP1002 Front Panel
The CTP1002 rear panel (Figure 2) includes:
The pinout of the DB-25 port connector is the same as provided by the quad cables
used on the larger CTP systems. The pinouts for this connector and the console
connector are provided in "Cables" on page 28.
Power LED —Illuminated green when power is connected and the front panel
power switch is set to ON position.
HDD LED —Illuminated red when the flash drive is in use.
Front power switch —Set to ON position when "1" is briefly pressed. Set to OFF
when "1" is pressed for 4 or more seconds.
Removable flash drive.
HD
Power input from the external 12VDC power supply provided with the unit.
Port 0 and port 1 DB-25 connectors—DB25 connectors for terminating EIA530,
RS-232, V.35, 4WTO, and T1 circuits.
COM 2 console connection—Provides an asynchronous TTY connection for
locally configuring the CTP system.
Fast Ethernet connector—Provides the 100-Mbps Ethernet connection to the IP
network by means of a local Ethernet switch or router.
USB connector.
POWER
Chapter 1: CTP System Overview
CTP1002
CTP1000-Series Models
5
Advertisement
Table of Contents
