Lift Assist Springs - Vulcan-Hart ERA Series Service Manual

ERA & EBD SERIES ELECTRIC FRYERS - REMOVAL AND REPLACEMENT OF PARTS
6. Reverse procedure to install.

LIFT ASSIST SPRINGS

NOTE: If one spring breaks, replace both springs.
1. Raise heating elements and place 2x4 lumber
under them for support. Heating elements are
to remain upright.
2. Loosen all eye bolt mounting nuts to release
tension on springs.
F25385 (May 2010)
3. Remove lift assist springs from the eye bolt
hooks.
4. Remove lift assist springs from the hangers.
5. To install springs:
A. Attach spring hook to hanger thru rear
door opening.
B. Attach spring hook to eye bolt and tighten
eye bolt mounting nut.
C. Remove 2x4 lumber and lower heating
elements.
6. Adjust spring tension as outlined under LIFT
ASSIST SPRING ADJUSTMENT in SERVICE
PROCEDURES AND ADJUSTMENTS.
Page 10 of 32