Table of Contents
Advertisement
Programming MAC 600 Device Without User Interface
Substitute Master Password
Revision G
Maintenance: Check out Procedure
the SD card is not formatted, the system will display Format SD
Card. You may format it by pressing the Enter key and storing the
system log or press the esc key to exit without formatting the SD
card.
1. Copy the released manufacturing software to an empty SD card that
has been formatted in a FAT 16 file system.
2. In the root folder on the SD card, create a file named Update.com.
3. Insert the SD card into the device.
4. Connect and switch on the external power supply.
5. Switch on the device. The battery LED located on the keypad will
start blinking in 15 seconds.
6. Wait for 160 seconds. The unit will switch OFF automatically.
7. Remove the SD card.
The device is programmed and ready to use.
NOTE
If the battery LED does not blink within 15 seconds, then Program
Failure is indicated.
If you do not have access to the system's password, you can create a
master password as follows.
1. At the prompt for the system password, enter 622600. A random 6-
digit number displays on the screen. For example, 876743.
2. Write the number down and create a new 6-digit number by adding
alternating digits from the random number as follows.
first and third digits,
second and fourth digits,
third and fifth digits,
fourth and sixth digits,
fifth and first digits, and
sixth and second digits.
Disregard the 10s column when adding the digits. The new number from
the example above would be 440020.
3. Enter the new number, then press the Enter key.
The System Setup menu displays. This process only works once, so
you should reprogram the password permanently.
4. Go to the Basic System menu.
5. Select Miscellaneous Setup.
TM
MAC
600
2047426-002
4-33
Advertisement
Table of Contents
