Table of Contents
Advertisement
Application Software Update
Revision G
Maintenance: Check out Procedure
5. Enter the service password 7763
6. Press Enter.
7. If the serial number already exists, the system displays the stored
serial number on the screen. Press the Enter key again if you wish to
change the serial number or press the esc key to exit the serial
number entry screen.
8. Enter the serial number using keys 1-10 and by selecting the
required character from the corresponding drop-down menu using
the arrow keys and the Enter key. (Use the back space key to
erase a wrong entry)
9. Go to Return and press Enter to exit the service menu.
NOTE
To verify if the serial number entry is correct or not, go to system
information
("Testing the System Information"
verify that the serial number displayed matches the one on the serial
number label.
1. Connect the external power supply and then switch ON the unit.
2. Insert the SD card formatted in FAT 16 file system with the released
MAC 600 software.
3. Select Setup using the function key.
4. Enter the set up password 1111.
5. Press the Enter key.
6. Press the Lead and F3 keys together.
A screen will open with the current SW and new SW version.
7. Press the Enter key to begin programming.
8. The system displays the following messages and then switches OFF.
Copying code to Main memory
Programming Flash
Programming over
System Shutting Down
9. If any error messages are displayed, please correct them accordingly
as per the message displayed and press the Enter key to restart
programming. To exit programming during error conditions, press
the esc key.
NOTE
If Boot SW is also updated from the one in the device, the system will
display Update Boot SW on the screen. Press the Enter key to
program Boot.
Do not remove the SD card until programming is complete. After
programming is complete, remove the SD card and restart the device
TM
MAC
600
2047426-002
on page 3-6) and
4-31
Advertisement
Table of Contents
