Raymarine AIS 350 Installation Instructions Manual page 70

3. Screw the 3 mounting studs (2) into the underside of the antenna.
4. Stick the supplied gasket (3) to the mounting surface, ensuring
that the holes on the gasket correspond with the drilled holes.
5. Route the cable as follows:
• For Option A, feed the cable down through the center hole.
• For Option B, route the cable along the cable channel.
6. Carefully place the antenna so the mounting studs pass through
the holes in the mounting surface.
7. Secure the antenna to the surface using the 3 thumb nuts (4).
Note:
• The thumb nuts supplied with your product may differ slightly
from those shown in the illustration.
• Only use the studs and thumb nuts supplied with your product.
• If you are replacing an older version of the GPS receiver, you
must mount the newer GPS receiver using only the studs and
thumb nuts supplied with the newer GPS receiver.
70
Pole mounting
If you want to pole-mount the GPS antenna, obtain a pole of suitable
length with a 1 inch 14 TPI thread.
1
2
3
1 GPS antenna
2 Pole mount adaptor
3 Mounting pole (not supplied)
D11642-2
AIS350 / AIS650