Raymarine AIS 350 Installation Instructions Manual page 69

5. Place the unit over the screws and move unit down to lock in
position
6. Fully tighten the screws.
Fitting GPS antenna
To fit the GPS antenna:
1. Select a suitable location for the GPS antenna as described
under GPS antenna location requirements.
2. Fit your GPS antenna using either the Surface mounting or Pole
mounting procedure, as appropriate.
3. Ensuring that cable routing and connection requirements as
detailed in the AIS installation instructions are followed.
AIS650 Class B transceiver
Surface mounting
When surface mounting the GPS antenna, you can route the cable
either centrally (Option A) or from the side of the antenna (Option B).
1. Remove the 3 screws securing the GPS antenna to its pole
mount adaptor, then remove the adaptor from the antenna.
2. Using the supplied gasket, mark the three 6 mm (0.25 in)
mounting holes.
• OPTION A: If the cable is going to pass through the mounting
surface, drill a 19 mm (0.75 in) center hole.
• OPTION B: If the cable is to be routed from the side of the
antenna (i.e. above the mounting surface), run the cable
through the cable channel (1). If you do not route the cable
through the channel, you could damage the cable.
A B
1
D11638-2
69