Raymarine AIS 350 Installation Instructions Manual page 62

that an additional NMEA 0183 or SeaTalk
to provide GPS data to external devices, as shown in the system
examples provided in this document.
You can check the GPS output status of your AIS650 by connecting
it to the ProAIS2 software (via the USB connection). Ensure that the
following GNSS sentences are disabled:
• GBS – Satellite Fault Detection;
• GGA – Global Positioning System Fix Data;
• GLL – Latitude, Longitude, Time of Fix and Status;
• RMC – Recommended Minimum Data.
To do this, ensure that these options are NOT ticked (NOT selected)
in the Configuration tab of the ProAIS2 software, as shown in the
following screenshot:
Note: Raymarine recommends that you make this check before
you use the AIS unit for the first time.
62
ng GPS receiver is used
AIS Silent mode connection
In addition to enabling AIS silent mode via a connected multifunction
display. The Power/data cable on the AIS unit includes 2 wires
which can be connected to a bespoke switch placed at a suitable
location on the vessel's dashboard to enable manual switching of
AIS silent mode.
Note: The AIS silent switch, where fitted will override a
multifunction displays AIS silent setting.
Connecting AIS silent wires
To connect a manual AIS silent switch to your system follow the
steps below:
2
1
3
US B
S T GP S ANT VHF ANT
P WR/Da ta
AIS350 / AIS650
D12091-1