Raymarine AIS 350 Installation Instructions Manual page 23

Required additional components
This product forms part of a system of electronics. Depending
on your requirements and system configuration, some or all of
the following additional components will also be required for full
operation.
• For displaying AIS targets — AIS-capable SeaTalk
0183 device (for example, multifunction display or instrument).
• VHF antenna. If you only have one antenna and you are using
the AIS unit in a system that also includes a VHF radio, Raymarine
recommends the use of a suitable AIS / VHF splitter (for example,
the Raymarine AIS100). This will enable you to use a single VHF
antenna for both the AIS and VHF radio units.
• For repeating GPS data to external NMEA 0183 devices —
NMEA 0183-compatible GPS receiver connected to the NMEA
0183 input on the AIS unit.
Note: For AIS650 units, do NOT attempt to use the included
GPS receiver to provide GPS data to an external device.
Doing so may cause erratic and degraded GPS performance.
The GPS receiver supplied with the AIS650 is intended to
provide GPS data for the AIS unit only. For more information,
refer to the GPS data for external devices
• Power and data cables — refer to
for suitable cables. Some installations may also require
extensions to data, power or antenna cables. Refer to the
Cables and connections and
sections for more information.
AIS350 Receiver
ng or NMEA
section.
3.3 Cables and connections
Chapter 6 Options and accessories
Typical Systems
AIS350 Basic system example (SeaTalk
AIS350
S ta tus AIS350 Re ce ive r
US B
P WR/Da ta S T VHF ANT
12 V / 24 V
Description
1 VHF antenna
2
SeaTalk ng Multifunction display
3.3
3
SeaTalk ng GPS receiver
ng only)
1 2
12 V
VHF
SeaT alk ng
Notes
To avoid potential data conflicts,
do NOT connect the multifunction
display to the AIS unit by NMEA
0183 and SeaTalk
time.
If your multifunction display
includes an internal GPS, a
dedicated external GPS receiver
may not be required.
3
12 V / 24 V *
D12084-2
ng at the same
23