Diagnostic Tool Connector - KYMCO MXU 450i Service Manual

11
. EFI SYSTEM
Apply oil onto a new O-ring.
When install the T-MAP sensor onto the
throttle body, being careful not to damage the
O-ring.
＊
Always replace an O-ring with a new one.
Install the set plate and tighten the screw
securely.
Apply oil onto a new O-ring.
When install the ISC and T-MAP sensor onto
the throttle body, being careful not to damage
the O-ring.
DIAGNOSTIC TOOL
CONNECTOR
INSPECTION
Remove front cover
Make sure of moving the shift lever into the
"N" or "P" position.
Remove diagnostic tool connector protect
sheath.
Turn the ignition switch to "ON"
Measure the voltage between the following
terminals of the diagnostic tool connector.
Terminal
BR/L (+) G/B (-)
B/L (+) W/L (-)
11-9
Sheath
Normal
Battery voltage
Battery voltage
－1 V
Injector
O-ring
Screw
Screws
Diagnostic Connector
MXU 450i
T-MAP sensor
ISC