Water Temperature Sensor - KYMCO MXU 450i Service Manual

11
. EFI SYSTEM
WTS SENSOR (Water Temperature
Sensor)
REMOVAL / INSTALLATION
Drain the coolant from the cooling system.
Disconnect the WTS sensor connector from
the sensor.
Remove the WTS sensor and O-ring.
Install a new O-ring and WTS sensor.
＊
Always replace an O-ring with a new
one.
Tighten the WTS sensor to the specified
torque.
Torque: 1.2 kgf-m (12 N-m, 8.6 lbf-ft)
Connect the WTS sensor connector.
Fill the cooling
recommended coolant.
INSPECTION
Measure the resistance at the WTS sensor
terminals.
STANDARD
ºC 60
Ω
703.8±40.9 260.7±15.1 111.1±7.8
11-5
system with the
90 120
MXU 450i
O-ring