Rear Body Panel/Rack - KYMCO MXU 450i Service Manual

2. Inspect the mufficr internally by sbaking the muf-
fler back and forth and Jjstening fo r rattles or loose
debris inside the muffler.
•NOTE: For additional details on cleaning the muf-
fler/spark arrester, see Section 2.
INSTALLING MUFFLER
1.
Using a new grafoil seal. place the muffler iuto
position engaging the mounting lugs into the
grommets: then slide tl1c muffler forward.
2 . ln.stall the two exhaust springs.
Rear Body Panel/Rack
REMOVING
I. Remove the rear rack; tlten remove a cap screw
securing the rear body panel/fender to the side
frante and Ute cap screws securing the rear fenders
to llic footwclls .
2. Disc01mcct the battery (negative cable first) and
remove from the battery compartment: then dis-
connect the starter relay wires and route the wiring
out of the compartment.
3. Remove the a.u,,;Jiarv brake reservoir from the
body but do not disconnect the hose; then route
a11d secure the hose and reservoir out of the way
making sure uot to spill brake flwd .
4. Using a small screwdri ver, remove tbe light con-
nectors from che frame; then rusconnect boili con-
nectors and remove dte rear body panel/fender,
8-9