Section 4: Operations; Removing/Installing Router Bit; Adjusting Bit Depth - Grizzly T27139 Owner's Manual

SECTION 4: OPERATIONS

Removing/Installing
Router Bit
This router is supplied with a
use with ⁄ " shank router bits. Carefully
1
4
inspect router bits for cracks, chips, or
other damage before installing. DO NOT
use router bits that have been dropped,
cracked, or damaged. The router bit may
shatter, causing serious injury.
To remove or install router bit:
1. DISCONNECT TOOL FROM POWER!
2. To access collet, release clamping
lever and remove laminate trim router
from base.
3. Align spindle lock button pin with spin-
dle shaft, and press lock button.
4. Use collet wrench to loosen collet nut,
and remove router bit (see Figure 7).
Router bit is sharp and will be hot
after use. Wear gloves to prevent
injury when removing bit.
Spindle
Lock Button
Collet
Wrench
Figure 7. Collet wrench and lock button.
Model T27139 (Mfd. Since 3/16)
5. Slide router bit to within
⁄ " collet for
1
4
To adjust bit depth using fixed base:
1. DISCONNECT TOOL FROM POWER!
2. Loosen clamping lever shown in
tom of collet, press lock button, then
securely tighten collet with wrench.
Note: The collet can be damaged if it
is tightened without a bit.

Adjusting Bit Depth

Unplug router and make sure switch
is OFF before inserting or removing
bit, making adjustments, or perform-
ing maintenance or service. DO NOT
make adjustments while router is
connected to power. Serious injury
may occure if this is ignored.
Figure 8, and adjust base to approxi-
mately desired height with the height
adjustment knob.
Height
Adjustment
Knob
Figure 8. Height adjustment knob.
⁄ " of the bot-
1
8
Clamping
Lever
-11
-