Subaru Ascent 2020 Quick Manual page 11

To retrieve the seat position with a button:
1. Turn the ignition switch to "ON".
2. While the select lever is in the "P" position, press button "1" or "2".
To set a seat position with the access key fob:
1. Make sure the select lever is in the "P" position with the parking brake on and the
ignition "OFF".
2. Adjust the seat to the desired position.
3. While holding the "SET" button, press and hold the unlock button on the access key
fob. A chirp sounds when the position is registered.
To retrieve the seat position with the access key fob:
1. Hold the access key fob.
2. Unlock and open the driver's door.
Head Restraint Adjustment
Pull the head restraint up to raise it. To lower it,
push it down while pressing the release button on
the top of the seatback. Each head restraint should
be adjusted so that the center of the head restraint
is closest to the top of the occupant's ears. This
adjustment should be made for any seating position,
front or rear, that has a new occupant.
You can adjust the angle of the front head restraints by tilting them forward. You will hear a
click when the restraint is locked. Pulling the head restraint as far forward as it will go will
allow it to return to the fully upright position.
Seatbelt Adjuster
Always position the seatbelt adjuster so the shoulder
belt passes over the middle of your shoulder without
touching your neck. Pull the adjuster out and slide it
up or down. Release the adjuster and make sure it is
locked in place.
TILT AND TELESCOPIC
STEERING COLUMN
Pull the lever down firmly to unlock, then adjust the
height and lengthwise position of the column. Push
the lever firmly back up to lock the column in place.
9