Shutdown And Cleaning - Graco 16H960 Operation, Parts, Repair

Operation

Shutdown and Cleaning

NOTICE
Failure to properly clean sprayer after each use will
result in hardened materials, damage to the sprayer, and
the warranty will no longer be valid. Do not store solvents
other than mineral spirits in sprayer.
Flushing Sprayer
Do not spray solvents through the spray tip. Clean the tip
in a bucket of compatible solvent.
Keep spray area well-ventilated. Keep a good supply of
fresh air moving through the area.
NOTICE
Protect the internal parts of this sprayer from water.
Do not submerge the sprayer in cleaning fluid. Openings
in shroud allow cooling of mechanical parts and electron-
ics inside. If water or cleaning fluid gets into these open-
ings, the sprayer could malfunction or become
permanently damaged.
1. Engage trigger lock and put prime/pressure relief
valve UP to release pressure.
ti19350a
ti14994a
2. Turn pressure control knob to prime/clean position.
3A2308A
3. Remove cup from sprayer.
4. Remove lid from cup.
5. Remove material liner and lid from cup and properly
ti19347a
6. Insert a new liner into cup and fill 1/2 full with appro-
ti19357a
ti19360a
ti19363a
dispose. Properly dispose any excess material left
in the liner.
ti15000a
ti19352a
priate flushing fluid. Screw on lid and attach cup to
sprayer. Shake sprayer to move flushing fluid
around and clean all wetted areas inside cup.
ti19365a
19