Repair
Clamshell
Removal
1. Engage trigger lock and put prime/pressure relief
valve in UP position to relieve pressure.
ti19350a
2. Remove material cup and battery.
ti19360a
3. Remove pump module from drive module. See
Pump Module/Drive Module, page 31.
4. Remove screws (42) from motor housing.
5. Remove screws (43) from clamshell.
ti19637a
3A2308A
ti19347a
ti19617a
42
ti19636a
43
6. Remove nut from ground stud. Remove ring termi-
nal and unscrew second nut from ground stud.
Remove ground stud from clamshell.
7. Carefully remove motor, motor housing, switch, con-
trol board, indicator lights, trigger lock, and static
wick from clamshell.
Installation
1. Insert control board into right half of clamshell.
2. Install two LED lights into designated slot in right
half of clamshell. Push wire bundle into slots in
clamshell.
ti19638a
ti19639a
ti19627a
ti19628a
33