Technical Data; Fcc Declaration For Battery Charger - Graco 16H960 Operation, Parts, Repair

Technical Data

Technical Data
Models 16H960, 16N654, 16N927, 16N655, 16N656
Sprayer:
Adjustable Pressure Range
Maximum working pressure
Weight
Dimensions:
Length
Width
Height
Storage temperature range ◆❖
Operating temperature range ✔
Storage Humidity Range
Sound Pressure Level
Vibration Level Acceleration
Wetted Parts
Charger:
Charging Time
Power Source
Battery:
Voltage
Capacity
◆
Pump damage will occur if fluid freezes in pump.
❖
Damage to plastic parts may result if impact occurs in low temperature conditions.
✔
Changes in coating viscosity at very low or very high temperatures can affect sprayer performance.
† per ISO 3744 measured at 3.1 feet (1m)
†† per ISO 5349, no load condition

FCC Declaration for Battery Charger

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. The equipment generates,
uses and can radiate radio frequency energy and, if not installed an used in accordance with the instructions, may cause harmful interference to
radio communications. However, there si no guarantee that interference will not occur in a particular installation. If this equipment does not cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measure:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
3A2308A
U.S.
1000 to 4000 psi
4000 psi
8.6 lb
14.5 in.
5.6 in.
12.8 in.
32° to 113° F
40° to 90° F
0% to 95% relative humidity, non-condensing
LpA = 79.0 dB, Sound Power = LWA = 90.0
2
Less than 8.2 feet/s 2.5 m/s
Brass, aluminum, 301 sstl, 440c sstl, carbide, FKM, TFE, PTFE, LDPE,
UHMWPE, Polypropylene, Nylon 6/6
50 minutes to 80%, 75 minutes to 100%
120 VAC / 240 VAC
28 VDC, Lithium Ion
2.4 Ah, 67 Wh
Metric
69 to 276 bar, 6.9 to 27.6 MPa
276 bar, 26.7 MPa
3.9 kg
(36.8 cm)
(14.2 cm)
(32.5 cm)
(0° to 45° C)
(4° to 32° C)
2
††
41