Test Print Condition Setting (Print Condition) - Toshiba B-EP2DL Series System Mode Manual

4. SYSTEM MODE (For Service Persons and System Administrators)

4.6.3 Test Print Condition Setting (PRINT CONDITION)

The print conditions for the Test Print should be specified before printing.
PRINT CONDITION
[POWER]
ISSUE COUNT 1
[POWER]
SENSOR NONE
[POWER]
TYPE AUTO
[POWER]
LABEL LEN. 63mm
[POWER]
PAPER NO FEED
[POWER]
<5>TEST PRINT
[POWER]
SLANT LINE(1DOT)
Notes:
1. When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
2. When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
3. When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this setting, repeat
mode is enabled and the key pressed is repeatedly entered.
4. The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
5. The default value at power on is PRINT CONDITION (test print condition parameter setting).
Test print condition parameter setting mode
Issue count setting
Print type setting (BATCH/STRIP)
Character print
Label length setting
Paper feed mode
System mode menu display (Test Print)
1-dot slant line print mode
Moves to the test print mode selected.
4- 55
EO13-33005
4.6 Test Print