Table of Contents
Advertisement
HOC Rod Position (Front Shown)
A
G
Figure 19
To adjust cut height:
1. Using the grab handle (A), raise the
deck until the desired hole in the HOC
rod (C) is above the top of the frame (F)
and washer (E). See Figure 19.
2. To raise cut height by 1/4" (6 mm), insert
spacer (B) on HOC rod (C). See
Figure 20.
3. Insert hair pin (D) in the hole and set
deck back down. Insert hair pins from
the outside facing inward.
NOTE: Ensure that washer (E) is positioned
between hair pin (D) and frame (F).
4. Repeat for three remaining HOC rods.
E
C
D
F
C
D
B
E
F
B
HOC Rod Position (Rear Shown)
HOC Rod Hair
Pin Position
1
2
3
4
5
6
For HOC over 4.25 in. (108 mm): See
ADDITIONAL CUTTING HEIGHT on
page 29.
GB - 28
Cut Height
Spacer
Inch (mm)
1.5 (38)
No
1.75 (44)
Yes
2.0 (51)
No
2.25 (57)
Yes
2.5 (64)
No
2.75 (70)
Yes
3.0 (76)
No
3.25 (83)
Yes
3.5 (90)
No
3.75 (95)
Yes
4.0 (102)
No
4.25 (108)
Yes
Figure 20
1
2
3
4
5
6
Hide quick links:
Advertisement
Table of Contents
