Disassemble Proportional Differential; Disassemble Planetary Spider Assembly - Meritor T-2111 Series Maintenance Manual

Section 3
Disassembly
Figure 9
RING
GEAR
DIFF. BRG.
CAGE
REAR
OUTPUT
SPACERS
BRAKE
ADAPTER
Disassemble Proportional
Differential
NOTE:
Refer to Figure 9 to disassemble the proportional
differential.
1. Remove the differential bearing cage-to-cover
capscrews and washers. Lift the bearing cage and
shaft assembly from the transfer case.
2. Remove the snap ring and the ring gear from the
shaft.
3. Remove the shaft, bearing cones and spacers. Press
the shaft out toward the large end of the bearing
housing.
4. Use a bearing puller to remove the bearing cups
from the housing.
5. Remove the sun gear from the front output shaft.
6. Remove the snap ring from the rear output shaft.
Remove the planetary spider assembly and spacer.
Page 10
Pro Gear and Transmission • 906 W. Gore St. Orlando, FL 32805 • 1 (877) 776-4600 / (407) 872-1901 • parts@eprogear.com
PLANET
GEAR
SUN
GEAR
PLANET
SHAFT
SET
SCREW
SPACER
Disassemble Planetary
Spider Assembly
1. Remove the snap ring from the ends of the planet
shafts.
2. Remove the thrust washer and planet gear from the
planet shafts.
3. Remove the set screws from the planet shafts.
4. Press the planet pins out of the spider. Use care
when handling the planet pins. If the nylon coating
on the pin is cut, the pin must be discarded.
PLANETARY
SPIDER
FRONT
OUTPUT