1 Introduction
Specifications and data
Hypoid pinion bearings
2 taper roller and 1 straight roller bearing
Differential unit
Final Drive Hypoid Gear Ratio (and bevel set teeth)*
Pinion to Drive Gear Backlash
Pinion to Crown Backlash Adjustment
Differential Bearing Cap Divergence
Differential Bearing Cap Divergence Adjustment
Thickness Range for the Shims fitted between the
Bevel Pinion Bearing Cage & the Differential Carrier
Drive Gear runout
Pinion Bearing Preload
* Verify with the Engineering reference the range of the ratio in current production because sometimes some ratios could be already
released but not currently in production.
2.47 (15/37): 2.64 (14/37): 2.85 (13/37): 3.08 (12/37):
3.36 (11/37): 3.67 (9/33): 3.40 (10/34): 4.11 (9/37):
4.63 (8/37): 5.29 (7/37): 6.17 (6/37)
0.21 ÷ 0.50 mm
Adjusting Rings
0.15 - 0.33 mm
using the Ring Nut Adjusters
0.10 - 0.15 - 0.35 - 0.50 mm
0.20 max mm
4 - 8 Nm without Pinion Seal
Meritor Differential Carrier 18X
7