Warranty And Liability - Siemens SINAMICS S120 Manual

Table of contents

Warranty and liability

The application examples in this document are not binding and do not claim to
Note
be complete regarding the configuration, equipping, and any eventuality. The
application examples do not represent specific customer solutions, but are only
intended to provide support for typical applications. You are responsible for the
proper operation of the described products. These application examples do not
relieve you of your responsibility regarding the safe handling when using,
installing, operating, and maintaining the equipment. By using these application
examples, you agree that Siemens cannot be made liable for possible damage
beyond the mentioned liability clause. We reserve the right to make changes to
these application examples at any time and without prior notice. If there are any
differences between the suggestions made in these application examples and
other Siemens publications, such as catalogs, the contents of the other
document(s) take priority.
We give no guarantee for the information contained in this document.
We accept no liability for any damage or loss caused by the examples, information,
programs, planning data or performance data described in these application
examples, irrespective of the legal basis for claims arising from such damage or
loss, unless liability is mandatory. For example, according to the product liability
law, in cases of malfeasance, gross negligence, due to endangerment of life, the
body or health, due to assumption of a guarantee for a product's characteristics of
state, due to malicious concealment of a defect or due to violation of basic
contractual obligations. However, claims for indemnification based on breach of
contract shall be limited to liability for damages to the contract-specific, foreseeable
damages, provided there is no mandatory liability for intent, acts of gross
negligence, harm to the life, body and health of human beings. Any change to the
burden of proof to your disadvantage is not covered hereby.
Any form of duplication of these application examples or excerpts hereof is not
permitted without the express consent of Siemens Industry Sector.
4
PROFIsafe SLS Override
Version 1.0, Entry ID: 81682475