Cisco Aironet 1570 Series Mounting page 44

Pole Mount Kit 3
Do not loop the metal band straps through the large open area between the pole clamp bracket and the
Caution
strap brackets (see
Position the strap and pivot brackets assembly on the pole as needed before tightening the metal band
Caution
straps. After the metal band straps are tightened to the full tension, the strap and pivot brackets
assembly's position on the pole cannot be adjusted unless the metal band straps are cut or disassembled.
Step 4 Tighten the metal band straps using the banding strap tool (BAND IT) (Cisco AIR-BAND-INST-TL=)
by following the operating instructions in the box with the tool. Ensure that the metal band straps are as
tight as possible.
Hold the PMK3 horizontal wall mount bracket against the pivot bracket such that the curved slots and
Step 5
the bolt holes line up.
Insert and hand-tighten four M8 x16 bolts (with flat and lock washers) into the bolt holes. Do not over
Step 6
tighten.
For off-angle poles, you can now rotate the mounting bracket as required. Rotate to ensure that the AP
Step 7
will be oriented vertically and that the LEDs on the base of the AP will be visible from the ground.
Note
Step 8 Make final adjustments, if needed, to the top edge of the horizontal wall mount bracket so that it is
horizontal. Ensure such that the AP will be oriented vertically and that the LEDs on the base of the AP
will be visible from the ground. Then tighten the bolts four bolts to 13 to 15 lb.ft (17.6 to 20.3 Nm).
Screw M8 bolts into three of the four bolt holes on the back side of the access point (Screw holes 1, 4,
Step 9
and 5 in
Do not screw in the bolts all the way. Leave a gap of about 0.13 inch (3.3 mm).
Position the three bolts on the access point into the wall mount bracket's keyhole slots. Check to ensure
Step 10
that the access point is properly seated in the slots. (see
Screw in the fourth M8 x 12mm hex head bolt into the non-keyhole type screw hole (Screw hole 6 in
Step 11
Figure
Using a 13 mm open-end or socket wrench, tighten all four M8 x 12mm hex head bolts to a torque of 13
to 15 lb.ft (17.6 to 20.3 Nm).
Continue with installing antennas, connecting the data cables, grounding the access point, and powering
Step 12
the access point. For information on these, see
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
3-44
Figure 3-22), because this does not properly secure the access point.
The horizontal wall mount bracket can be rotated to up to 45
to the pivot bracket. This allows you to compensate for the tilt of off-angle poles, such as tilted
streetlight arms.
Figure 3-31)
3-31).
Chapter 3
o
from the vertical, while attached
Figure 3-34)
Chapter 4, "Installing Other Components."
Mounting the Access Point
OL-32138-01