Strand Mounting Using Smk2 - Cisco Aironet 1570 Series Mounting

Strand Mount Kit 2
Figure 3-4 AP Mounted Using SMK2 - Dimensions in inches [and millimeters]

Strand Mounting Using SMK2

When mounting the access point on a cable strand where you need to accommodate a cable bundle also,
you must use SMK2 strand mount kit.
Note The access point must be installed on a cable strand by a professional cable installer.
Table 3-2
Table 3-2
Material Needed
SMK2 strand mount kit
Four M8 x16mm button-head bolts, and its washers
5 mm hex wrench
13 mm box-end wrench
To mount the access point, follow these steps:
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
3-10
61.6
2.42
200.7
7.90
lists the materials you need to strand mount the AP using SMK2.
Materials Needed to Mount the AP using SMK2
Chapter 3 Mounting the Access Point
In Kit?
Yes
Yes
No
No
OL-32138-01