Fisher & Paykel OR90SDBGFX3 Installation Instructions Manual page 4

Hide thumbs Also See for OR90SDBGFX3:

Table of Contents

1. Drill four 8 mm diameter holes for the fixing screws (two in the wall and two in the floor - see Fig.3) and insert

the plastic plugs supplied.

Before drilling the holes, check that you will not damage any pipes or electrical wires.

2. Attach the anti-tilt bracket to the floor and rear wall using the four screws supplied, as shown in Fig. 3.

3. After attaching the anti-tilt bracket securely, slide the cooker into place. Ensure that the left rear foot slides

under the bracket, as shown in Fig.3.

4. Replace the kickstrip using the two screws.

• When sliding the cooker into place be careful not to trap the power supply cable in the anti-tip

bracket. Pay extra attention to the gas connection hose.

• Beware of sharp edges when removing or replacing the drawer.

Fig. 3 Attaching the anti-tilt bracket and sliding the cooker into place

https://producthelp.fisherpaykel.com/eu/Cook/Freestanding_Cookers/Dual_Fuel/OR90SDBGFX3/User_Guide_OR90SDBGFX...

Updated: Thu, 26 Mar 2020 03:34:19 GMT

Table of Contents