4.Troubleshooting for Peripheral Units
Shift Over, Over Skew, Image Skew
1.
Adjust side-to-side registration for the feed tray.
2.
If adjusting side-to-side registration does not solve the problem, adjust skew by inserting a shim
behind the connection plate.
3.
If you are using non-carbon paper (thickness 2 or less), use the tab sheet holder. See
Tab
Holder.
Attaching the Tab Holder
By attaching the tab sheet holder, you can prevent air from escaping at the trailing edge of the paper.
This gives better paper separation.
1.
Pull the tray out until it stops.
2.
Take out the tab fence from the pocket on the right-hand side of the paper tray.
3.
Set the side fences to the tabs for the paper size to be loaded, and then load the paper.
4.
Attach the tab fence, and then align the end fence gently against the paper you loaded while
818
(Adjusting Tray Side-to-Side
(Correcting
Skew)
Registration)
Attaching the