Stack Remains Up; Attaching The Small Tab Sheet Holder (Thick Paper With Narrow Width) - Ricoh Pro 8300S Troubleshooting Manual

4.Troubleshooting for Peripheral Units
(12mm). Problem solved?
Yes Finished.
No Problem cannot be corrected in the field.

Stack Remains Up

Cause:
The paper stack remains up after the tray has been opened because the pressure of the spring [A] on
the skew correction plate is stuck between the side fence, so that the stack [B] remains up even after
the plate is lowered from under it.
This problem occurs only when the tray is opened. This does not occur during paper feed because the
bottom plate does not operate.
Solution:
Caution the operator to check the top of the stack when the tray is opened.
If paper remains up, remove the stack and load it in the tray again.

Attaching the Small Tab Sheet Holder (Thick Paper with Narrow Width)

When B5 SEF to SRA4 size paper of Paper Weight 8 is fed from the last portion of the paper stack, the
airflow decreases, resulting in paper misfeed.
Cause
When the paper is fed from the last portion of the paper stack, the bottom plate partially blocks the air
nozzle and the airflow becomes smaller. As the amount of air is not sufficient to lift the paper,
misfeeding occurs.
This tends to occur when A4/Letter size paper is fed, because only 2 float air nozzles are used, and the
amount and speed of airflow is weaker.
Layout of Float Air Nozzles
816